Installation Video

  • Remove magazine and check to make sure firearm is clear and safe
  • Pull slide rearward approximately 0.25″ and hold
  • Release slide forward and release slide lock
  • Pull slide forward off of the gun
  • Remove recoil spring
  • Remove barrel
  • Replace with META Tactical 16″ barrel
  • Re-install slide onto the gun by sliding it from the front of the gun to the rear
  • Make sure the frame rails are engaged with the slide rails
  • Press button and open rear door
  • Insert the gun into the chassis
  • Close the rear door until button clicks
  • Push firing pin into chassis
  • Screw on the compensator clockwise onto barrel
  • Pull the slide back using the charging handle

Create your own bullpup conversion kit today

Was this article helpful?

Related Articles

Need Support?

Can't find the answer you're looking for?
Contact Support